Motor Control Center

A Motor Control Center (MCC) is an assembly that controls several or all-electric motors centrally. There are multiple enclosed sections and a common power bus. Each section has a combination starter, which consists of a motor starter, fuses or circuit breakers, and a power disconnect. It is also possible to equip a motor control center with push buttons, indicator lights, variable-frequency drives, programmable logic controllers, and metering equipment. In some buildings, it may be combined with the electrical service entrance.

Typically, Motor Control Centers can be found in large industrial or commercial buildings containing a lot of electrical motors that must be controlled centrally, such as an electrical room or mechanical room.

Specification and Features – Motor Control Center (MCC) & Power Control Center (PCC)

• Techno Modular Design with flexibility in construction / fully bolted with concealed hinges for all doors.
• Suitable for Indoor and Outdoor installations with IP-54 / 55 as per IEC 60529 : 2001
• Fixed & Withdrawable type in Single front & Double Front Execution up to Form-4B.
• Bus Bar Rating up to 6300A with E91E grade Aluminum/ Electrolytic grade Copper Bus Bars.
• Type tested for Short Circuit 4000A for 65 KA rms / 1sec and 143KA peak fault withstand as per IS: 8623 and IEC: 61439.
• Type tested for Temperature Rise 800A to 4000A from CPRI Bhopal as per IS: 8623 and IEC: 61439.
• 10 Tank spray based tricationic phosphating treatment and electrostatic coating with epoxy based powder.
• Standard Paint Shades : RAL-7035, RAL-7032 and 631 as per IS:5 Structure Finish Powder Coating.
• All doors & covers are provided with PU Foam gasket to ensure the Ingress Protection.
• PU Foam gasket temperature withstand capacity -40 Deg C to + 100 Deg C.
• Panel height upto 2500mm (including 100mm High Plinth/Base).
• Panel Width 900mm Withdrawable execution & for Fixed Execution depends on application.
• 600mm for Single Front Withdrawable , 1200mm for Double Front Withdrawable & For Fixed Execution depends on application.